Drexel dragonThe Math ForumDonate to the Math Forum



Search All of the Math Forum:

Views expressed in these public forums are not endorsed by Drexel University or The Math Forum.


Math Forum » Discussions » Software » comp.soft-sys.matlab

Topic: Specify/change the error used by train command
Replies: 4   Last Post: Feb 4, 2013 2:15 PM

Advanced Search

Back to Topic List Back to Topic List Jump to Tree View Jump to Tree View   Messages: [ Previous | Next ]
AM76

Posts: 6
Registered: 4/11/12
Specify/change the error used by train command
Posted: Feb 3, 2013 10:15 PM
  Click to see the message monospaced in plain text Plain Text   Click to reply to this topic Reply

Hello
I am in a work to use the neural network in a specific form that the output of the NN is multiplied by a system (Like G) and want to make output of G tracks a desired target. Therefore, the error between target and G should be used to train the NN so I can't use train (as far as I know) command directly because the NN train the net from the error between the target and the direct NN output. I was wondering how to use train command in such a system?

Note. This system is used in model reference control in Simulink/Neural network, but I don't use Simulink.



Point your RSS reader here for a feed of the latest messages in this topic.

[Privacy Policy] [Terms of Use]

© Drexel University 1994-2014. All Rights Reserved.
The Math Forum is a research and educational enterprise of the Drexel University School of Education.