The Math Forum

Search All of the Math Forum:

Views expressed in these public forums are not endorsed by NCTM or The Math Forum.

Math Forum » Discussions » Software » comp.soft-sys.matlab

Notice: We are no longer accepting new posts, but the forums will continue to be readable.

Topic: Help!!! Fuzzy logic Simulink
Replies: 4   Last Post: Feb 4, 2013 3:46 PM

Advanced Search

Back to Topic List Back to Topic List Jump to Tree View Jump to Tree View   Messages: [ Previous | Next ]
Ahmed Hakim

Posts: 22
Registered: 1/22/09
Re: Help!!! Fuzzy logic Simulink
Posted: Feb 4, 2013 3:46 PM
  Click to see the message monospaced in plain text Plain Text   Click to reply to this topic Reply

Hello Dear

I faced this problem

simply write it as follows:

with these quotations

good luck

"Raj " <> wrote in message <hp2i9l$rle$>...
> Actually i am new to this newsreader, so i posted a new thread in order to be more catchy.I have tried what u have adviced by just writing dvr_fuzzy only, bt now i am getting this error:
> Error in 'dvr_fuzzy/Fuzzy Logic Controller1': Parameter 'dvr_fuzzy' cannot be evaluated. MATLAB error message: Compilation of 'dvr_fuzzy' in progress.
> please provide me your email id, so that i can send you the matlab files , then you can tell me correctly where i am doing a mistake
> thanks
> "Arkadiy Turevskiy" <> wrote in message <hp2c9t$h4m$>...

> > Not sure why you have created a new thread with the same question.
> > As I said in my earlier reply open the Fuzzy Logic Controller block and type dvr_fuzzy for a block parameter instead of dvr_fuzzy.fis you have now.
> > Arkadiy
> >
> > "Raj " <> wrote in message <hovqtg$36a$>...

> > > Hello, i have created simulink model for dynamic voltage restorer(dvr) i.e dvr.mdl and to control voltage injection i have used pi controller and my model works fine and i am getting simulation without error. Then i replaced pi controller by fuzzy logic controller and thus form dvr_fuzzy.mdl and also formed dvr_fuzzy.fis in FIS editor. After writing dvr_fuzzy.fis in parameter of fuzzy logic controller(got after double clicking on block),, then opening dvr_fuzzy.fis in FIS editor and exporting to workspace: dvr_fuzzy
> > > Now after that when i am running the model , i receive following error
> > > Error in 'dvr_fuzzy/Fuzzy Logic Controller1': Parameter 'dvr_fuzzy.fis' cannot be evaluated. MATLAB error message: Reference to non-existent field 'fis'.
> > >
> > > Please help.

Point your RSS reader here for a feed of the latest messages in this topic.

[Privacy Policy] [Terms of Use]

© The Math Forum at NCTM 1994-2018. All Rights Reserved.