Drexel dragonThe Math ForumDonate to the Math Forum



Search All of the Math Forum:

Views expressed in these public forums are not endorsed by Drexel University or The Math Forum.


Math Forum » Discussions » Software » comp.soft-sys.matlab

Topic: 3D contour plot with extra info
Replies: 1   Last Post: Mar 26, 2013 4:58 AM

Advanced Search

Back to Topic List Back to Topic List Jump to Tree View Jump to Tree View  
Derek Goring

Posts: 3,892
Registered: 12/7/04
Re: 3D contour plot with extra info
Posted: Mar 26, 2013 4:58 AM
  Click to see the message monospaced in plain text Plain Text   Click to reply to this topic Reply

On Tuesday, March 26, 2013 8:25:05 PM UTC+13, Ryan wrote:
> I would like to display a 3D contour plot, but with additional information. The 3D contour plot is basically redundant in most uses (since the contours are generally matched to elevation) but I would like to overlay contours corresponding to a function of x, y, and z. For example, if I am trying to optimize a system with 3 parameters x, y, and z, and I want the system output displaying as a fourth bit of information at each point on the 3D surface (high output = red, low output = blue, but no direct correlation to surface peaks), how might I go about it?

Utter rubbish.
You obviously know nothing about contour plots.
If you were lost in the mountains and had only a topo map to find your way out, you would not say the map is "basically redundant".
Silly.





Point your RSS reader here for a feed of the latest messages in this topic.

[Privacy Policy] [Terms of Use]

© Drexel University 1994-2014. All Rights Reserved.
The Math Forum is a research and educational enterprise of the Drexel University School of Education.