The Math Forum

Search All of the Math Forum:

Views expressed in these public forums are not endorsed by NCTM or The Math Forum.

Math Forum » Discussions » Inactive » comp.soft-sys.math.mathematica

Notice: We are no longer accepting new posts, but the forums will continue to be readable.

Topic: Limiting Output Based on Z Axis of Plotd3d[Evaluate@Table[PDF[NormalDistribution
Replies: 3   Last Post: Apr 20, 2013 5:55 AM

Advanced Search

Back to Topic List Back to Topic List Jump to Tree View Jump to Tree View   Messages: [ Previous | Next ]
David Park

Posts: 1,560
Registered: 5/19/07
Re: Limiting Output Based on Z Axis of Plotd3d[Evaluate@Table[PDF[NormalDistribution
Posted: Apr 20, 2013 5:55 AM
  Click to see the message monospaced in plain text Plain Text   Click to reply to this topic Reply

It would help if you copied (select, right click, CopyAs Input Text) and
pasted your code into the posting proper. It does not fit into the heading.

David Park

From: Garrett Fisher []

Good Day,

I am plotting some bell curves using the function in the subject line.
The PDF of NormalDist produces static Z values - which is fine - except I
wish to limit them. I would like to show XY data at Z 0, 10, 20, 30 and so
forth - with an intended gap in the Plot for Z 1-9, 11-19, 21-29. I am
beginning to think that getting into the actual data output of the Table
might be necessary. I am fine with that - I am just a bit new at Mathematica
- so I don't know where to start to figure that part out.

Thanks for any help!!!

Point your RSS reader here for a feed of the latest messages in this topic.

[Privacy Policy] [Terms of Use]

© The Math Forum at NCTM 1994-2018. All Rights Reserved.