Drexel dragonThe Math ForumDonate to the Math Forum



Search All of the Math Forum:

Views expressed in these public forums are not endorsed by Drexel University or The Math Forum.


Math Forum » Discussions » Software » comp.soft-sys.matlab

Topic: ni daq 6008 configuration problem
Replies: 4   Last Post: Aug 6, 2013 5:37 PM

Advanced Search

Back to Topic List Back to Topic List Jump to Tree View Jump to Tree View   Messages: [ Previous | Next ]
Steven Lord

Posts: 17,944
Registered: 12/7/04
Re: ni daq 6008 configuration problem
Posted: Aug 6, 2013 12:12 PM
  Click to see the message monospaced in plain text Plain Text   Click to reply to this topic Reply



"mado " <elec_mnf@yahoo.com> wrote in message
news:ktp4h3$lkd$1@newscl01ah.mathworks.com...
> any help with daq ???

You didn't say in your original message in this thread what happened. All
you said was " the range should be changed to +10 to -10 but that didn't
happened" and that's not detailed enough to know what help you're looking to
receive. [Did you get a range of -5 to 5? 0 to 10? -20 to 20? Did your
hardware start smoking or explode? Did it give you unexpected results in the
correct range?]

The code you posted is probably also going to be impossible to run without
that specific piece of hardware, which limits how many CSSM readers are
going to be able to help. You should contact Technical Support (using the
instructions in my signature) and state exactly what happened and what you
expected and work with them to determine the cause of the behavior you're
seeing and a workaround or solution.

--
Steve Lord
slord@mathworks.com
To contact Technical Support use the Contact Us link on
http://www.mathworks.com




Point your RSS reader here for a feed of the latest messages in this topic.

[Privacy Policy] [Terms of Use]

© Drexel University 1994-2014. All Rights Reserved.
The Math Forum is a research and educational enterprise of the Drexel University School of Education.