Drexel dragonThe Math ForumDonate to the Math Forum



Search All of the Math Forum:

Views expressed in these public forums are not endorsed by Drexel University or The Math Forum.


Math Forum » Discussions » Software » comp.soft-sys.matlab

Topic: Stream data form MATLAB to Simulink
Replies: 6   Last Post: Jan 30, 2013 1:51 PM

Advanced Search

Back to Topic List Back to Topic List Jump to Tree View Jump to Tree View   Messages: [ Previous | Next ]
Phil Goddard

Posts: 351
Registered: 1/27/12
Re: Stream data form MATLAB to Simulink
Posted: Dec 10, 2012 1:13 PM
  Click to see the message monospaced in plain text Plain Text   Click to reply to this topic Reply

There is absolutely no need to use a pause.

To see this,
- Open a new model
- connect a Constant block to a Display block
- change the final time to inf.
- start the model.

Then from within MATLAB (either the command line or within a file) type
>> set_param('untitled/Constant','Value','30');
and notice that the display changes.
Do the same for other gain values and again see the display change.

Your model is no doubt more complex than this, but the same concept applies.

Phil.



Point your RSS reader here for a feed of the latest messages in this topic.

[Privacy Policy] [Terms of Use]

© Drexel University 1994-2014. All Rights Reserved.
The Math Forum is a research and educational enterprise of the Drexel University School of Education.