Drexel dragonThe Math ForumDonate to the Math Forum



Search All of the Math Forum:

Views expressed in these public forums are not endorsed by Drexel University or The Math Forum.


Math Forum » Discussions » Software » comp.soft-sys.matlab

Topic: Simhydraulics
Replies: 0  

Advanced Search

Back to Topic List Back to Topic List  
Ahmed shoier

Posts: 5
Registered: 3/1/09
Simhydraulics
Posted: Jan 18, 2013 5:39 PM
  Click to see the message monospaced in plain text Plain Text   Click to reply to this topic Reply

I am using Matlab 2008 and using the module of Simhydarulic to build a electrohydraulic circuit working and controlled by PID controller. This controller control servo 4/3 valve. I put the transfer function of the servo valve but for the 4/3 direction control valve i dont't have maximum area and maximum opening. Actually the required response from the simulation get only when i am using max area 10 mm and max. opening 10 mm. If i want to change Area to be 100 mm (which is right value) i get very bad response (Highly oscillation). but if use area 10 mm i got the actual response as real plant. By the way if i use max. are 10 mm2 this impossible coz. that is mean the spool diameter is .33 mm which is not practice value. Any one help me to solve this problem?



Point your RSS reader here for a feed of the latest messages in this topic.

[Privacy Policy] [Terms of Use]

© Drexel University 1994-2014. All Rights Reserved.
The Math Forum is a research and educational enterprise of the Drexel University School of Education.