Drexel dragonThe Math ForumDonate to the Math Forum

Search All of the Math Forum:

Views expressed in these public forums are not endorsed by Drexel University or The Math Forum.

Math Forum » Discussions » Software » comp.soft-sys.matlab

Topic: Matlab .fig in a Word 2007 document
Replies: 1   Last Post: May 2, 2013 12:10 PM

Advanced Search

Back to Topic List Back to Topic List Jump to Tree View Jump to Tree View   Messages: [ Previous | Next ]

Posts: 2,221
Registered: 12/6/04
Re: Matlab .fig in a Word 2007 document
Posted: May 2, 2013 12:10 PM
  Click to see the message monospaced in plain text Plain Text   Click to reply to this topic Reply

"Susan" wrote in message <kltdqg$4qm$1@newscl01ah.mathworks.com>...
> Hi all,
> I am writing a report in Word 2007 and copying my figures (.fig) into the document. It works fine but because I use a lot of accents and symbols in my graph axes, I use xlabel(.. 'interpreter','latex'), ylabel(.. 'interpreter','latex'). However, if I close Matlab and the document and reopen the document only, the axes are nonsense. If I run Matlab again the axis labels return to normal. However, I'm worried that those reading the document won't have a clue what is going on. Is there a way to stop this from happening? Aside from saving the doc as a .pdf and also sending that on, I don't know what else to try.
> Any suggestions are welcome!!

What if you copy the figures as jpegs instead of figs into Word (using the MATLAB saveas command/option)?

Point your RSS reader here for a feed of the latest messages in this topic.

[Privacy Policy] [Terms of Use]

© The Math Forum 1994-2015. All Rights Reserved.