Drexel dragonThe Math ForumDonate to the Math Forum



Search All of the Math Forum:

Views expressed in these public forums are not endorsed by Drexel University or The Math Forum.


Math Forum » Discussions » Software » comp.soft-sys.matlab

Topic: step size problem
Replies: 0  

Advanced Search

Back to Topic List Back to Topic List  
lady firmament

Posts: 14
Registered: 10/17/12
step size problem
Posted: May 12, 2013 8:26 PM
  Click to see the message monospaced in plain text Plain Text   Click to reply to this topic Reply

Warning: Unable to reduce the step size without violating minimum step size of 6.5766258709624053E-16 for 2 consecutive times at
time 0.18511556138638474. Continuing simulation with the step size restricted to 6.5766258709624053E-16 and using an effective
relative error tolerance of 0.012375476261614015, which is greater than the specified relative error tolerance of 1.0E-6. This
usually may be caused by the high stiffness of the system. Please check the model 'model_3' or increase the Max consecutive min
step size violation parameter in the solver configuration pane
**** Hi all.
I am trying to run electrohydraulic simulink model, but it cannot run after showing the above warning description. Let me know how shall i solve that error.
please kindly help me.



Point your RSS reader here for a feed of the latest messages in this topic.

[Privacy Policy] [Terms of Use]

© Drexel University 1994-2014. All Rights Reserved.
The Math Forum is a research and educational enterprise of the Drexel University School of Education.