The Math Forum

Search All of the Math Forum:

Views expressed in these public forums are not endorsed by NCTM or The Math Forum.

Math Forum » Discussions » Software » comp.soft-sys.matlab

Notice: We are no longer accepting new posts, but the forums will continue to be readable.

Topic: Issue with .exe file created by deploytool
Replies: 0  

Advanced Search

Back to Topic List Back to Topic List  

Posts: 22
Registered: 4/19/12
Issue with .exe file created by deploytool
Posted: May 13, 2013 2:56 PM
  Click to see the message monospaced in plain text Plain Text   Click to reply to this topic Reply


I have a simple MATLAB code which reads the serial port and displays the output of *IDN? . I am using the deploytool to compile it (to serialRead.exe) and use it on a different machine without MATLAB (MCR installed).

1. When serialRead.exe is executed, it doesn't display anything, and I get back to the command prompt. It appears as if there is no output. However, after about 2 minutes I see a message with the output of *IDN?

2. At the end of execution the .exe file doesn't give back the control (ie, I don't see the command prompt; The cursor keeps blinking. I get the control back only when I issue a CTRL+C.

Any idea what I am doing wrong? (The output is OK, but the delay and the behavior of the program is not.)


Point your RSS reader here for a feed of the latest messages in this topic.

[Privacy Policy] [Terms of Use]

© The Math Forum at NCTM 1994-2018. All Rights Reserved.