Drexel dragonThe Math ForumDonate to the Math Forum



Search All of the Math Forum:

Views expressed in these public forums are not endorsed by Drexel University or The Math Forum.


Math Forum » Discussions » Software » comp.soft-sys.matlab

Topic: using JOYSTICK in SIMULINK to give output to ARDUINO
Replies: 1   Last Post: Jun 30, 2013 2:41 AM

Advanced Search

Back to Topic List Back to Topic List Jump to Tree View Jump to Tree View   Messages: [ Previous | Next ]
Haaris Quadri

Posts: 1
Registered: 5/13/13
using JOYSTICK in SIMULINK to give output to ARDUINO
Posted: May 13, 2013 3:54 PM
  Click to see the message monospaced in plain text Plain Text   Click to reply to this topic Reply

i am doing my project that i have made in simulink. i am using the joystick blocks from example in simulink VRcraneJoystick then add the components from arduino example to write the output from my joystick with a certain gain to my servo. all the simulation works. but some time even when i put the simulation in "inf" mode. its stops anhd shows error. and dosent start again. i have to restart matlab for it to run again for the same time.

i am using Matlab 2012a
arduino UNO
win 8 64 bit



Point your RSS reader here for a feed of the latest messages in this topic.

[Privacy Policy] [Terms of Use]

© Drexel University 1994-2014. All Rights Reserved.
The Math Forum is a research and educational enterprise of the Drexel University School of Education.