Drexel dragonThe Math ForumDonate to the Math Forum



Search All of the Math Forum:

Views expressed in these public forums are not endorsed by Drexel University or The Math Forum.


Math Forum » Discussions » Software » comp.soft-sys.matlab

Topic: XPC Target Boot configuration
Replies: 6   Last Post: Jul 17, 2013 2:03 PM

Advanced Search

Back to Topic List Back to Topic List Jump to Tree View Jump to Tree View   Messages: [ Previous | Next ]
Gordon Weast

Posts: 728
Registered: 12/7/04
Re: XPC Target Boot configuration
Posted: Jul 17, 2013 2:03 PM
  Click to see the message monospaced in plain text Plain Text   Click to reply to this topic Reply

Please contact MathWorks tech support. The person who worked on the bug
will be contacted for more information if needed.



Salim wrote:
> Dear Gordon, I found a bug report in mathworks.com. Can this be the
> reason for me? or it is fixed in 2013a?
> Below, I attached the description of bug.
> 784428
> Summary
> xpctargetping fails when a RealTek Gigabit Ethernet card is used for
> host-target communication.
>
> Description
> Hosts cannot communicate correctly with xPC targets via a RealTek
> Gigabit Ethernet card. Certain Ethernet cards are not properly
> initialized because the PHY registers on the Ethernet cards take a very
> long time to modify (especially those with device ID 0x8167).




Point your RSS reader here for a feed of the latest messages in this topic.

[Privacy Policy] [Terms of Use]

© Drexel University 1994-2014. All Rights Reserved.
The Math Forum is a research and educational enterprise of the Drexel University School of Education.