Drexel dragonThe Math ForumDonate to the Math Forum



Search All of the Math Forum:

Views expressed in these public forums are not endorsed by Drexel University or The Math Forum.


Math Forum » Discussions » Software » comp.soft-sys.matlab

Topic: error message with daq
Replies: 0  

Advanced Search

Back to Topic List Back to Topic List  
mado

Posts: 116
Registered: 5/24/12
error message with daq
Posted: Aug 2, 2013 4:12 PM
  Click to see the message monospaced in plain text Plain Text   Click to reply to this topic Reply



i have matlab 2012a and i want to use ni daq so i typed 'daqhwinfo" and error message appeared

Error using daqhwinfo (line 42) To learn about using data acquisition devices on the win64 platform, see the documentation on the session-based interface.

when i typed "daq.getVendors()" it gives

%Data acquisition vendor 'National Instruments':

ID: 'ni'
FullName: 'National Instruments'
AdaptorVersion: '3.1 (R2012a)'
DriverVersion: 'unknown'
IsOperational: false

%Warning: Diagnostic Information from vendor: NI: There was a driver error while loading the MEX file to communicate with National Instruments hardware. It is possible that the NI-DAQmx driver is not installed or is older than the required minimum version of '9.1'. Additional information: 'Invalid MEX-file 'F:\mat12\toolbox\daq\daq\+daq\+ni\private\mexNIDAQmx.mexw64': The specified module could not be found.'



Point your RSS reader here for a feed of the latest messages in this topic.

[Privacy Policy] [Terms of Use]

© Drexel University 1994-2014. All Rights Reserved.
The Math Forum is a research and educational enterprise of the Drexel University School of Education.