Drexel dragonThe Math ForumDonate to the Math Forum



Search All of the Math Forum:

Views expressed in these public forums are not endorsed by Drexel University or The Math Forum.


Math Forum » Discussions » Software » comp.soft-sys.matlab

Topic: Simulink: Label signals in a Vector individually
Replies: 2   Last Post: Aug 8, 2013 5:31 AM

Advanced Search

Back to Topic List Back to Topic List Jump to Tree View Jump to Tree View   Messages: [ Previous | Next ]
Phil Goddard

Posts: 349
Registered: 1/27/12
Re: Simulink: Label signals in a Vector individually
Posted: Aug 7, 2013 12:45 PM
  Click to see the message monospaced in plain text Plain Text   Click to reply to this topic Reply

Yes and No.

You cannot label the individual signals _after_ the mux block.

But you can label them _before_ the mux block and inherit the names after the block.
To inherit signal names enter <> (i.e. a less than immediately followed by a greater than) as the signal name, then Simulink will do the rest.

Phil.



Point your RSS reader here for a feed of the latest messages in this topic.

[Privacy Policy] [Terms of Use]

© Drexel University 1994-2014. All Rights Reserved.
The Math Forum is a research and educational enterprise of the Drexel University School of Education.